YOU NEED TO INSTALL FEET UNDER THE SYSTEM. USE RUBBER LONG FEET UNDER IT!
(Printer Required: Ender 5 Plus)
NOTE: DO NOT ATTEMPT THIS ON A STOCK HOTEND. This print is too EPIC for a failure to occur! Micro Swiss All Metal Hot End. IS highly recommended.
This is a pipe organ speaker system 2.1 Left Right And SUB And LID 4 Pieces
L&R uses a 2 inch full range speakers.
Subwoofer uses a 5 inch Sub.
Print Each Piece as in the STL orientation
No Supports Required.
10% Infill is recommended But higher is better.
200C For PLA
Retraction set to 5 and Retraction speed 30
RCA Connector:
https://www.ebay.com/itm/202725256366?hash=item2f335decae:g:7N4AAOSwARpdHXin
Left And Right Speakers:
SubWoofer: Any 5 inch or..
Material Cost: About 4 Spools!! This is a BIG PRINT! $100 And Under.
Printer Required: Ender 5 Plus.
(Printer Required: Ender 5 Plus)
No Supports Required! Orient The Model To Not Need Any.
10% Infill is recommended But higher is better.
200C For PLA
Retraction set to 5 and Retraction speed 30
Print Speed 50